{"{0} remainder {1}":"{0} 餘數 {1}","12-hour":"12 小時制","24-hour":"24 小時制","A {0}, {1} triangle; inscribed circle radius {2}, circumscribed {3}.":"{0}、{1}三角形；內切圓半徑為{2}，外接圓{3}。","acute":"銳角","Add up durations such as video clips, laps, or work sessions, and subtract breaks: each line can be h:mm:ss, mm:ss, decimal hours or minutes such as 2.5h or 90m, or plain seconds. The total keeps counting past 24 hours rather than wrapping round, so 25:00:00 means twenty-five hours.":"加總影片片段、圈數或工作時段等持續時間，並扣除休息時間：每行可以是h:mm:ss、mm:ss、小時或分鐘的小數格式（例如2.5h或90m），也可以只輸入秒數。總時間超過24小時後會繼續累計，不會重新從零開始，因此25:00:00代表25小時。","Angle A (°)":"角A（°）","Angle A between them (°)":"兩者之間的角A（°）","Angle B (°)":"角B（°）","Angles":"角度","Answer":"答案","Area":"面積","As a decimal":"以小數表示","Could not read: {0}. Use h:mm:ss, mm:ss, or forms like 1h 30m.":"無法讀取：{0}。請使用h:mm:ss、mm:ss，或1h 30m這類格式。","Decimal places (0 for a remainder)":"小數位數（輸入0以顯示餘數）","digits in brackets repeat forever":"括號中的數字會無限循環","Dividend (number to divide)":"被除數（要除的數字）","Divisor":"除數","Enter a time such as 14:30, 1430, or 2:30 pm.":"輸入時間，例如14:30、1430或2:30 pm。","Enter at least one time, such as 1:30:00, 45:10, or 2h 15m.":"請至少輸入一個時間，例如1:30:00、45:10或2h 15m。","Enter whole numbers: a dividend of zero or more and a divisor above zero.":"請輸入整數：被除數必須是0以上，除數必須大於0。","equilateral":"等邊","hours:minutes:seconds":"小時：分鐘：秒鐘","In hours":"以小時表示","In minutes":"以分鐘表示","In seconds":"以秒數表示","isosceles":"等腰","Long division calculator":"長除法計算機","Long division works one digit at a time: bring down the next digit, see how many times the divisor goes into the number you have, write that digit in the answer, multiply it back, and subtract to get what is left over. After the last digit, either stop with a remainder or carry on into decimal places by bringing down zeros. A fraction whose divisor has prime factors other than 2 and 5 never ends: its digits repeat.":"長除法一次處理一個位數：帶下下一位數字，確認除數可以從目前的數字中除出幾次，將該位數寫入答案，再乘回除數並相減，得到剩餘數值。處理完最後一位後，可以停在餘數，或帶下零繼續計算小數位數。若分母的質因數除了2和5之外還有其他數字，分數就不會終止，小數位會循環。","Military":"軍用時間","Military time converter":"軍用時間轉換器","No triangle has these measurements: check that the angles add up to less than 180°.":"沒有三角形符合這些測量值：請確認角度總和小於180°。","No triangle has these measurements: side a is too short to reach the third side.":"沒有三角形符合這些測量值：邊a太短，無法連接到第三邊。","obtuse":"鈍角","Perimeter":"周長","right-angled":"直角","said as \"{0} hours\"":"讀作「{0} hours」","scalene":"不等邊","Side a":"邊a","Side a, opposite A":"邊a，與角A相對","Side b":"邊b","Side c":"邊c","Side c between them":"兩者之間的邊c","Sides":"邊長","Sides a, b, and c are opposite angles A, B, and C. The calculator uses the law of cosines, c² = a² + b² − 2ab·cos C, for three sides or two sides and the angle between them, and the law of sines, a ÷ sin A = b ÷ sin B, otherwise. Two sides and an angle not between them can give two triangles, one, or none, and all are shown. The area comes from Heron's formula.":"邊a、b、c分別與角A、B、C相對。輸入三邊，或輸入兩邊及其間的角度時，計算機會使用餘弦定理c² = a² + b² − 2ab·cos C；其他情況則使用正弦定理a ÷ sin A = b ÷ sin B。輸入兩邊及不在兩邊之間的角度時，可能得到兩個、一个或零個三角形，結果會全部顯示。面積使用海龍公式計算。","Solution {0}":"解答{0}","terminates":"有限小數","The 24-hour clock counts the hours of the day from 00 to 23, so 2:30 pm is 14:30; military style drops the colon and is read as fourteen-thirty hours. Midnight is 00:00 at the start of a day (12:00 AM) and is sometimes written 24:00 at the end of one; noon is 12:00 (12:00 PM).":"24小時制會將一天的時間從00計算到23，因此2:30 pm是14:30；軍用格式會省略冒號，讀作fourteen-thirty hours。午夜是一天開始時的00:00（12:00 AM），有時也會在一天結束時寫成24:00；中午是12:00（12:00 PM）。","The ambiguous case: two different triangles fit":"模稜兩可的情況：有兩個不同的三角形符合條件","These sides cannot make a triangle: each side must be shorter than the other two together.":"這些邊長無法組成三角形：每一邊都必須短於另外兩邊的總和。","Three sides (SSS)":"三邊（SSS）","Time calculator":"時間計算機","Time, in either format":"時間，任一格式皆可","Times, one per line; start a line with − to subtract":"時間，每行一個；在行首輸入−以扣除","Total":"總計","Triangle calculator":"三角形計算機","Triangle drawn to scale":"按比例繪製的三角形","Triangles found":"找到的三角形數量","Two angles and another side (AAS)":"兩角及另一邊（AAS）","Two angles and the side between (ASA)":"兩角及其間的邊（ASA）","Two sides and another angle (SSA)":"兩邊及另一個角（SSA）","Two sides and the angle between (SAS)":"兩邊及其間的角（SAS）","Working":"計算過程","You know":"已知"}